GE LPS-D, Инструкция по эксплуатации

Страница: 313 / 436

GE Power Management LPS-D Line Protection System 12-
7
12 ASCII COMMUNICATIONS 12.1 INTRODUCTION
12
TIMe Displays the current LPS-D
time SETTINGS Do you want to change time? (Y/N):
Enter new time (hh:mm:ss):
Command is executed Enter letter Y or
N; 6 digit time
code
LINEs Changes the number of
lines the relay will display
before pausing for the user
to read VIEW Enter the number of LINES PER PAGE (24/25/48/
50): Enter 24, 25, 48,
or 50
GEModem Changes communications
type to GE-Modem after
user has logged out SETTINGS None
ECHo Toggles the echo state and
reports its status VIEW Echo is turned ON (OFF) None
PORTparam Changes and displays the
current port parameters for
the LPS-D serial
communications port SETTINGS Do you want to change communication port
parameters? (Y/N):
Interface is (0 - RS232, 1 - RS485): 0
Enter Interface Type (0 - RS232, 1 - RS485):
Baud rate is 9600
Enter baud rate (19200, 9600, 4800, 2400, 1200,
300):
Parity check type is (0 -none, 1 - odd, 2 - even): 0
Enter parity check type (0 -none, 1 - odd, 2 - even):
Number of stop bits is 1
Enter number of stop bits (1 or 2):
Save changes? (Y/N):
Y displays
parameter to be
changed, N
exits; 0 for
RS233, 1 for
RS485; press
ENTER for no
change; choose
baud rate
matching PC
port; Enter 0, 1,
or 2;
Enter 0, 1, or 2;
Enter Y or N
END Ends the session VIEW None
Table 12–3: ASCII COMMAND LIST (Sheet 6 of 7)
ASCII
Command
Mnemonic Command Description Lowest
Level
Password
Needed Relay Prompt User Response