GE LPS-D, Инструкция по эксплуатации

Страница: 312 / 436

12-
6
LPS-D Line Protection System GE Power Management
12.1 INTRODUCTION 12 ASCII COMMUNICATIONS
12
RELTest Selects and runs a given
relay test. Puts the relay in
test mode (Contact A!
Reports test function
operation). MASTER Disable Outputs? (Y/N):
Select the function to be tested (2 to 49)
To stop the test in progress enter I
To see the list of functions enter H
To quit without suspending the test enter Q
To quit press ESC
Enter your choice: 2
Z1 AG test function is routed to contact A!
Enter letter Y or
N; one to two
digit number, 1
to 49; enter letter
H or Q
ACCESS Allows the user to change
privilege level VIEW Enter Password:? User-defined
password
OSCtrg Start oscillography
recording VIEW Are you sure? (Y/N): y
Oscillography is triggered
Enter letter Y or
N
CHNLtest Test PLC channel. The test
starts when a B is entered
and ends only when an E
is entered. MASTER To begin Channel Test enter B, To end Channel
Test enter E Enter letter B or
E
PLAYBack Re-run a fault produced
earlier or test case for
relay. There are three
choices for running a fault:
1) re-run a fault saved in
the relay; 2) with factory
test data; 3) download
oscillography into relay
and run fault ACTION To run the relay on Fault Data enter Fault Number
To run the relay on factory test case enter F
To run the relay on downloaded test data enter D
To quit press ESC
Enter your choice: 5
The fault is absent
There is no factory test data in the relay
There is no downloaded data in the relay
Fault number, F,
D, or ESC
LUIPass Display coded LUI
passwords. See decoding
table in Chapter 8 VIEW MMI PASSWORDS
Settings Password: [DHLPPPPPPPPPPPP
Control Password: [AEIPPPPPPPPPPPP
Master Password: [MBFPPPPPPPPPPPP
None
HELP Displays the ASCII
command mnemonics as
well as descriptions of
each command VIEW None
OUTPuts Displays the current state
of the digital outputs VIEW
Output Contact #1, T1=0
Output Contact #3, T3=0
Output Contact #5, A1=0
Output Contact #7, A3=0
Output Contact #9, A5=0
Output Contact #11, A7=0
O utput C ontact #13, K T 1=0
O utput C ontact #15, K T 3=0
Output Contact #17, C1=0 Output Contact #2, T2=0
Output Contact #4, T4=0
Output Contact #6, A2=0
Output Contact #8, A4=0
Output Contact #10, A6=0
Output Contact #12, A8=0
O utput C ontact #14, K T 2=0
O utput C ontact #16, K T 4=0
Output Contact #18, C2=0
None
DATE Displays the current LPS-D
date SETTINGS Do you want to change date? (Y/N):
Enter new date (mm/dd/yy):
Command is executed Enter letter Y or
N; 6 digit date
code
Table 12–3: ASCII COMMAND LIST (Sheet 5 of 7)
ASCII
Command
Mnemonic Command Description Lowest
Level
Password
Needed Relay Prompt User Response