Festo EMCA-EC-67 CO Series, Описание

Страница: 92 / 416

5 Modbus TCP with FHPP
92 Festo – EMCA-EC-C-HP-EN – 2017-11e – English
5.2 Parameterisation of the Modbus TCP subscriber
Before connecting the EMCA to the Modbus master, parameterise the controller interface, device
profile, TCP port and timeout:
– with the FCT plug-in EMCA
è
Section 5.2.1
Connection of the EMCA with the PC
è
Description “Integrated drive with I/O and
Modbus TCP interfaces, EMCA-EC-DIO-...”
5.2.1 Parameterisation with the FCT plug-in EMCA
1. Create drive configuration
è
Help for the FCT plug-in EMCA.
– Define the control interface (Control Interface):
– “Digital I/O (Digital I/O)”
2. On the application data page (Application Data), determine the control interface (Control Interface):
– “Modbus TCP”
3. Optionally determine on the controller page (Controller):
– Enable with (Enabled by), determination of the required signals for controller enable:
– “Fieldbus” (Fieldbus)
– “Digital input ‘Enable’ and fieldbus” (Digital Input 'Enable' and Fieldbus) – factory setting
4. Optionally, on the Fieldbus page, Operation Parameters tab, define the following:
– Optionally, change TCP-Port (factory setting TCP-Port 502)
– Optionally activate the timeout (Timeout) (factory settings: not activated, 100 ms is the default
value when activated)
è
Section 5.3.12
5. Optionally, on the Fieldbuspage, FHPP+ Editor tab, define the following:
– Use the parameter channel (Use Parameter Channel):
– Checkbox not set: “FHPP Standard” – factory setting
– Checkbox set: “FHPP St FPC”
6. Establish an online connection.
7. Activate the FCT device control (Device Control).
8. Download and save (Store) the parameters.
9. Optionally, on the Controller page, network settings tab (Network Settings), change the network
settings (Setup network settings):
– “DHCP server active” (DHCP server active, factory setting)
– “Obtain IP address automatically” (Obtain an IP adress automatically)
– “Use the following IP address” (fixed setting of IP address, subnet mask and standard gateway)