Endress+Hauser Proline Promag H 500, Руководство по эксплуатации

Страница: 215 / 240

Proline Promag H 500 PROFIBUS DP Technical data
Hauser 215
Low flow cut off The switch points for low flow cut off are user-selectable.
Galvanic isolation The outputs are galvanically isolated from one another and from earth (PE).
Protocol-specific data
Manufacturer ID 0x11
Ident number 0x1570
Profile version 3.02
Device description files (GSD,
DTM, DD) Information and files under:
•
www.endress.com
On the product page for the device: Documents/Software → Device drivers
• www.profibus.org
Supported functions • Identification & Maintenance
Simplest device identification on the part of the control system and
nameplate
• PROFIBUS upload/download
Reading and writing parameters is up to ten times faster with PROFIBUS
upload/download
• Condensed status
Simplest and self-explanatory diagnostic information by categorizing
diagnostic messages that occur
Configuration of the device
address • DIP switches on the I/O electronics module
• Via operating tools (e.g. FieldCare)
System integration Information regarding system integration .
• Cyclic data transmission
• Block model
• Description of the modules
16.5 Power supply
Terminal assignment →  39
Supply voltage
Order code for
"Power supply" terminal voltage Frequency range
Option D DC24 V ±20% –
Option E AC100 to 240 V –15…+10% 50/60 Hz, ±4 Hz
Option I
DC24 V ±20% –
AC100 to 240 V –15…+10% 50/60 Hz, ±4 Hz
Power consumption Transmitter
Max. 10 W (active power)
Current consumption Transmitter
• Max. 400 mA (24 V)
• Max. 200 mA (110 V, 50/60 Hz; 230 V, 50/60 Hz)
Power supply failure Depending on the device version, the configuration is retained in the device memoryor in
the pluggable data memory (HistoROM DAT).