Endress+Hauser Proline Promag H 500, Руководство по эксплуатации

Страница: 112 / 240

Commissioning Proline Promag H 500 PROFIBUS DP
112 Hauser
Navigation
"Setup" menu → I/O configuration
‣
I/O configuration
I/O module 1 to n terminal numbers →  112
I/O module 1 to n information →  112
I/O module 1 to n type
→  112
Apply I/O configuration →  112
Alteration code →  112
Parameter overview with brief description
Parameter Description User interface / Selection /
User entry
Factory setting
I/O module 1 to n terminal numbers Shows the terminal numbers used by the I/O
module.
• Not used
• 26-27 (I/O 1)
• 24-25 (I/O 2)
• 22-23 (I/O 3)
• 20-21 (I/O 4) –
I/O module 1 to n information Shows information of the plugged I/O
module. • Not plugged
• Invalid
• Not configurable
• Configurable
• Profibus DP –
I/O module 1 to n type Shows the I/O module type. • Off
• Current output
*
• Current input
*
• Status input
*
• Pulse/frequency/switch
output
*
Off
Apply I/O configuration Apply parameterization of the freely
configurable I/O module. • No
• Yes No
Alteration code Enter the code in order to change the I/O
configuration. Positive integer 0
* Visibility depends on order options or device settings
10.6.6 Configuring the current input
The "Current input" wizard guides the user systematically through all the parameters that
have to be set for configuring the current input.
Navigation
"Setup" menu → Current input
‣
Current input 1 to n
Terminal number →  113