Endress+Hauser Proline Promag H 500, Руководство по эксплуатации

Страница: 120 / 240

Commissioning Proline Promag H 500 PROFIBUS DP
120 Hauser
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Measuring value at minimum
frequency The Frequency option is
selected in the Operating
mode parameter (→  117)
and a process variable is
selected in the
Assign
frequency output parameter
(→  119).
Enter measured value for
minmum frequency. Signed floating-point
number Depends on country
and nominal
diameter
Measuring value at maximum
frequency The Frequency option is
selected in the Operating
mode parameter (→  117)
and a process variable is
selected in the
Assign
frequency output parameter
(→  119).
Enter measured value for
maximum frequency. Signed floating-point
number Depends on country
and nominal
diameter
Failure mode The Frequency option is
selected in the Operating
mode parameter (→  117)
and a process variable is
selected in the
Assign
frequency output parameter
(→  119).
Define output behavior in
alarm condition. • Actual value
• Defined value
• 0 Hz 0 Hz
Failure frequency The Frequency option is
selected in the Operating
mode parameter (→  117)
and a process variable is
selected in the
Assign
frequency output parameter
(→  119).
Enter frequency output value
in alarm condition. 0.0 to 12 500.0 Hz 0.0 Hz
Invert output signal – Invert the output signal. • No
• Yes No
* Visibility depends on order options or device settings