CTC Union GSW-3208M, Руководство пользователя

Страница: 48 / 148

Chapter 6. Manage / Configure the Switch
48
Some syntax are supported for port selection.
1. interface ethernet 1/x and “ x ” is port number. All the settings after this command will be applied to this port. For
example, “interface ethernet 1/5” and all the settings after this command will be applied to Port 5.
2. interface ethernet 1/x,y,z,... and “ x ”, “ y ”, “ z ",.. are port number. All the settings after this command will be applied
to these ports. For example, “interface ethernet 1/2,4,7” and the settings after this command will be applied to Port 2,
Port 4, and Port 7.
3. interface ethernet 1/x-y and “ x ”,” y ” are port number. All the settings after this command will be applied to ports in
this range. For example, “interface ethernet 1/4-7” and the settings after this command will be applied to Port 4, Port
5, Port 6, and Port 7. (Port 4~7)
4. interface ethernet 1/w,x,..,y-z and “ w ”,” x ”,” y ”,” z ” are port number. All the settings after this command will be
applied to those ports. For example, “interface ethernet 1/1,2,4-7” and the settings after this command will be
applied to Port 1, Port 2, Port 4, Port 5, Port 6, and Port 7. (Port 4~7)
Entering “interface ethernet 1/5”, and its prompt will become ...
(config)# interface ethernet 1/5
(config-if)#
Enter “?” at the prompt, the sub-command list will be shown.
------------------------------------------------------------------------------------------------------------
(config-if)# ?
exit Exit from current mode
help Show available commands
history Show a list of previously run commands
logout Disconnect
quit Quit commands
channel-group Adds a port to a trunk
description Interface specific description
dot1x Configures 802.1x port-based access control
duplex Configures duplex operation
end Exit from interface mode
flowcontrol Enables flow control during autoneg