CTC Union GSW-3208M, Руководство пользователя

Страница: 58 / 148

Chapter 6. Manage / Configure the Switch
58
spanning-tree edge-port command is used to set the interface port(s) as edge port. And no spanning-tree edge-
port command is used to set it as non-edge port. “Edge port” means the interface port(s) are connected to end
device(s) but not switch-to-switch connection.
spanning-tree port-priority x command is used to set the spanning tree port priority value on the interface port(s).
“ x ” is the port-priority value and its valid value is 0~240. If the path cost for all ports on a switch are the same, the
port with the highest priority (lowest value) will be forwarded when looping happens. If more than one port have the
same highest priority, the port with lowest port number will be forwarded.
spanning-tree spanning-disabled command is used to disable spanning tree function on the interface port(s). And
no spanning-tree spanning-disabled command will enable it.
27 speed command
This command is used to set the operation speed of the interface port(s).
(config-if)# speed ?
auto Set port speed to be auto
10 Set port speed to be 10M
100 Set port speed to be 100M
1000 Set port speed to be 1G
speed auto command will set the interface port(s) to auto-negotiation mode.
speed 10 command will set the interface port(s) to 10M speed.
speed 100 command will set the interface port(s) to 100M speed.
speed 1000 command will set the interface port(s) to 1000M(gigabit) speed.