CTC Union GSW-3208M, Руководство пользователя

Страница: 42 / 148

Chapter 6. Manage / Configure the Switch
42
Entering “queue ?”, the sub-commands will be shown.
(config)# queue ?
bandwidth Assigns WRR weights to QoS priority queues
mode Assigns priority queues
queue bandwidth x y z command is used to set the weighting of Normal, Medium, and High priority queues for
WRR operation. (Low priority queue is always weight1). “ x ” is the weighting of Normal priority queue. “ y ” is the
weighting of Medium priority queue. “ z ” is the weighting of High priority queue. And their valid number is 0~3.
(0:weight1 / 1:weight2 / 2:weight4 / 3:weight8).
queue mode strict/wrr command is used to select the traffic scheduling mode. If “strict” is selected, the higher
priority queue always get bandwidth service first. If “wrr” is selected, bandwidth is shared between queues with their
weighting.
25 radius-server command
This command is used to configure the settings for RADIUS Server. The settings will be used in 802.1x operation.
Entering “radius-server ?”, the sub-commands will be shown.
(config)# radius-server ?
host Sets the port as a host port
key Sets the RADIUS encryption key
port Sets the RADIUS server network port
radius-server host x.x.x.x command is used to set the IP address of RADIUS Server for 802.1x operation. “ x.x.x.x ”
is the IP address.
radius-server key xxx command is used to set the security key to handshake with RADIUS Server. “ xxx ” is the key
string.
radius-server port x command is used to set the communication port of RADIUS Server. “ x ” is the port number and
its valid value is 1~65535.
26 rate-limit command
This command is used to define the unit and operation mode of rate limit operation. The unit could be 128Kbps to
30Mbps. And the rate limit on each port is done with the level number of each port multiplied with this unit.
rate-limit unit x command is used to set the unit for rate limit operation. “ x ” is the unit number and its valid value is
128-30000. (Kbps)