Cisco 3750G - Catalyst Integrated Wireless LAN Controller, Руководство по настройке

Страница: 643 / 1204

30-5
Catalyst 3750 Switch Software Configuration Guide
OL-8550-02
Chapter 30 Configuring System Message Logging
Configuring System Message Logging
The logging synchronous global configuration command also affects the display of messages to the
console. When this command is enabled, messages appear only after you press Return. For more
information, see the
“Synchronizing Log Messages” section on page 30-6 .
To re-enable message logging after it has been disabled, use the logging on global configuration
command.
Setting the Message Display Destination Device
If message logging is enabled, you can send messages to specific locations in addition to the console.
Beginning in privileged EXEC mode, use one or more of the following commands to specify the
locations that receive messages. This procedure is optional.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 logging buffered [ size ] Log messages to an internal bufferon a standalone switch or, in the case
of a switch stack, on the stack master. The range is 4096 to 2147483647
bytes. The default buffer size is 4096 bytes.
If the standalone switch or the stack master fails, the log file is lost unless
you previously saved it to flash memory. See Step 4.
Note
Do not make the buffer size too large because the switch could run
out of memory for other tasks. Use the
show memory privileged
EXEC command to view the free processor memory on the switch.
However, this value is the maximum available, and the buffer size
should
not be set to this amount.
Step 3 logging host Log messages to a UNIX syslog server host.
For host , specify the name or IP address of the host to be used as the
syslog server.
To build a list of syslog servers that receive logging messages, enter this
command more than once.
For complete syslog server configuration steps, see the “Configuring
UNIX Syslog Servers” section on page 30-12 .
Step 4 logging file flash: filename
[ max-file-size [ min-file-size ]]
[ severity-level-number | type ]
Store log messages in a file in flash memory on a standalone switch or, in
the case of a switch stack, on the stack master.
• For filename , enter the log message filename.
•
(Optional) For max-file-size, s pecify the maximum logging file size.
The range is 4096 to 2147483647. The default is 4096 bytes.
• (Optional) For min-file-size, s pecify the minimum logging file size.
The range is 1024 to 2147483647. The default is 2048 bytes.
•
(Optional) For severity-level-number | type, specify either the logging
severity level or the logging type. The severity range is 0 to 7. For a
list of logging type keywords, see
Table 30-3 on page 30-10 . By
default, the log file receives debugging messages and numerically
lower levels.
Step 5 end Return to privileged EXEC mode.