Cisco 3750G - Catalyst Integrated Wireless LAN Controller, Руководство по настройке

Страница: 1052 / 1204

42-4
Catalyst 3750 Switch Software Configuration Guide
OL-8550-02
Chapter 42 Configuring Fallback Bridging
Configuring Fallback Bridging
Default Fallback Bridging Configuration
Table 42-1 shows the default fallback bridging configuration.
Fallback Bridging Configuration Guidelines
Up to 32 bridge groups can be configured on the switch.
An interface (an SVI or routed port) can be a member of only one bridge group.
Use a bridge group for each separately bridged (topologically distinct) network connected to the switch.
Do not configure fallback bridging on a switch configured with private VLANs.
All protocols except IP (Version 4 and Version 6), Address Resolution Protocol (ARP), reverse ARP
(RARP), LOOPBACK, and Frame Relay ARP are fallback bridged.
Creating a Bridge Group
To configure fallback bridging for a set of SVIs or routed ports, these interfaces must be assigned to
bridge groups. All interfaces in the same group belong to the same bridge domain. Each SVI or routed
port can be assigned to only one bridge group.
Note
The protected port feature is not compatible with fallback bridging. When fallback bridging is enabled,
it is possible for packets to be forwarded from one protected port on a switch to another protected port
on the same switch if the ports are in different VLANs.
Table 42-1 Default Fallback Bridging Configuration
Feature Default Setting
Bridge groups None are defined or assigned to a port. No
VLAN-bridge STP is defined.
Switch forwards frames for stations that it has
dynamically learned Enabled.
Spanning tree parameters:
• Switch priority
•
Port priority
•
Port path cost
•
Hello BPDU interval
• Forward-delay interval
•
Maximum idle interval
• 32768.
•
128.
•
10 Mbps: 100.
100 Mbps: 19.
1000 Mbps: 4.
•
2 seconds.
• 20 seconds.
•
30 seconds.