Cisco 3750G - Catalyst Integrated Wireless LAN Controller, Руководство по настройке

Страница: 145 / 1204

5-23
Catalyst 3750 Switch Software Configuration Guide
OL-8550-02
Chapter 5 Managing Switch Stacks
Configuring the Switch Stack
Provisioning a New Member for a Switch Stack
Note This task is available only from the stack master.
Beginning in privileged EXEC mode, follow these steps to provision a new member for a switch stack.
This procedure is optional.
To remove provisioned information and to avoid receiving an error message, remove the specified switch
from the stack before you use the
no form of this command.
Step 2
switch stack-member-number priority
new-priority-number
Specify the stack member number and the new priority for the stack
member. The stack member number range is 1 to 9. The priority value
range is 1 to 15.
You can display the current priority value by using the show switch user
EXEC command.
The new priority value takes effect immediately but does not affect the
current stack master. The new priority value helps determine which stack
member is elected as the new stack master when the current stack master
or switch stack resets.
Step 3
end Return to privileged EXEC mode.
Step 4 reload slot stack-member-number Reset the stack member, and apply this configuration change.
Step 5 show switch stack-member-number Verify the stack member priority value.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1 show switch Display summary information about the switch stack.
Step 2
configure terminal Enter global configuration mode.
Step 3 switch stack-member-number provision
type
Specify the stack member number for the preconfigured switch. By
default, no switches are provisioned.
For stack-member-number , the range is 1 to 9. Specify a stack member
number that is not already used in the switch stack. See Step 1.
For type , enter the model number of a supported switch that is listed in
the command-line help strings.
Step 4 end Return to privileged EXEC mode.
Step 5 show running-config Verify the correct numbering of interfaces in the running configuration
file.
Step 6
show switch stack-member-number Verify the status of the provisioned switch. For stack-member-number ,
enter the same number as in Step 2.
Step 7
copy running-config startup-config (Optional) Save your entries in the configuration file.