Bio-Tek ELx405, Руководство оператора

Страница: 163 / 250

Decontaminate the Washer
|
133
Caution. When reinstalling the manifold, only tighten the
screw-washer-spring assembly that holds it in place until you
feel the mechanical stop. You will damage the instrument if
you continue tightening past this point, and will void your
warranty .
8. Reassemble the manifold and end plates, making sure that the two o-rings
are in place prior to reassembly.
Do not overtighten the manifold
screws.
9. Re-attach the mist shield:
Align the mist shield with the washer so it is resting on top of the two
posts, and the two thumbscrew holes in the shield are lined up with the
two holes in the front base of the washer. (Refer to
Figure 16
in the
section
Attaching the Mist Shield
,
Chapter 2
.)
Insert the two thumbscrews and finger-tighten only ( use no tools ).
10. Prime the system by running DAY_RINSE or a similar Maintenance or
Prime program. Watch for leaks. If fluid leaks out of the back of the
instrument, firmly seat the tubing. If fluid leaks from the manifold, try
disassembling and carefully reassembling.
11. Discard the used gloves and cloths using a Biohazard trash bag and an
approved Biohazard container.
12. Verify dispenser performance visually or by performing the
Dispense
Precision Test
in
Chapter 5
,
Performance Verification/Qualification
Tests
.
ELx405 Operator's Guide