BeaconMedaes MedPlus TotalAlert, Эксплуатация и обслуживание

Страница: 163 / 376

Page 2-8 MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
Error Codes and Troubleshooting Tips
Chapter 2: Troubleshooting Procedures
Error Codes and Troubleshooting Tips
Area Alarm
The error codes for the Area Alarm Modules are used to help identify and solve
problems with the facility’s gas system or the MedPlus TotalAlert® Alarm
Network (see table 2-1 on page 2-8).
Table 2-1. Area Alarm Module Error Codes
Error Code Error Description Possible Corrective Action
A 01 Transducer pressure below
sensor range. Turn on the shutoff valves, or check the
source equipment. Go to RAP 2.1 on
page 2-13.
A 02 Transducer pressure above
sensor range. Check the source equipment, or replace
the transducer. Go to RAP 2.2 on page 2-
14.
A 03 Transducer communication
time out. Connect the transducer, or replace the
transducer. Go to RAP 2.3 on page 2-14.
A 04 Area Alarm Module RAM
error. Replace the Area Alarm Module. Go to
RAP 2.9 on page 2-18.
A 05 Area Alarm Module ROM
error. Replace the Area Alarm Module. Go to
RAP 2.10 on page 2-19.
A 06 Transducer status fault. Replace the transducer. Go to RAP 2.4 on
page 2-15.
A 07 Incorrect transducer connected
to Area Alarm Module. Install the correct gas-specific transducer.
Go to RAP 2.5 on page 2-16.
A 08 Area Alarm Module pro-
grammed as vacuum, but units
are not inHg or mmHg. Install the correct gas-specific Area
Alarm Module. Go to RAP 2.8 on page
2-18.
A 09 Area Alarm Module pro-
grammed as pressure, but are
units not in PSI or kPa. Install the correct gas-specific Area
Alarm Module. Go to RAP 2.8 on page
2-18.
A 10 Transducer is programmed as
an invalid type of gas. Install the correct gas-specific transducer.
Go to RAP 2.6 on page 2-16.
A 11 Transducer short circuit
detected. Replace the transducer wiring. Go to
RAP 2.7 on page 2-17.