BeaconMedaes MedPlus TotalAlert, Эксплуатация и обслуживание

Страница: 362 / 376

Preventive Maintenance Schedule
Permanent records of all test results for alarm systems should be made at the
time of installation and at all required intervals as specified by NFPA 99 (see
table 6-1 on page 6–31).
Table 6-1. Preventive Maintenance Schedule
Š
Contact BeaconMedæs Technical Support for information on having these tests performed by a
BeaconMedæs Service Representative.
Function Procedure
Gas pressures Check the readings on the area alarm module digital dis-
plays daily.
Audible alarm signals
Š
Test once a month by pressing the test keys on each
front panel (see “Master Alarm Self-Test” on page 2-5),
(see “Area Alarm Self-Test” on page 2-6), and (see
“Local Alarm Self-Test” on page 2-6).
Visual alarm signals
Š
Test once a month by pressing the test keys on each
front panel (see “Master Alarm Self-Test” on page 2-5),
(see “Area Alarm Self-Test” on page 2-6), and (see
“Local Alarm Self-Test” on page 2-6).
Transducer visual indicators
Š
Inspect once a month (see “Transducer” on page 2-11).
Alarm system components
Š
Check every alarm component for wear.
Power and signal wiring
Š
Inspect all wiring for good condition.
Electrical connections
Š
Check all electrical connections for tightness, and tight-
en as needed.
Gas hosesw (on local-mount
transducers) Inspect hoses for cracking, wear, collapse, or leakage
annually.
General appearance Check cleanliness. Clean if necessary, see “Cleaning” on
page 6-28.
MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728) Page 6-31
Preventive Maintenance
Chapter 6: General Procedures
6