BeaconMedaes MedPlus TotalAlert, Эксплуатация и обслуживание

Страница: 177 / 376

Page 2-22 MedPlus TotalAlert® Alarm Network Operation and Maintenance Manual (205728)
Service Required
Chapter 2: Troubleshooting Procedures
2.14 Service Required
1. Service Required displays on the Master Alarm.
Yes No
L J
Go to “Final Actions” on page 2-7.
2. Master Alarm is connected to the source equipment properly.
Yes No
L J
Connect the source equipment to the Master Alarm. Refer to
either the
MedPlus TotalAlert® Alarm Network Installation
Instructions or the MedPlus TotalAlert® Alarm Network—
Conversion Kits Installation Instructions , if needed. If this
solves the problem, go to “Final Actions” on page 2-7.
Otherwise, go to step 3.
3. If the problem still exists, call BeaconMedæs Technical Support.
2.15 Gas or Vacuum Wrong Gas
1. Wrong Gas displays on the Master Alarm.
Yes No
L J
Go to “Final Actions” on page 2-7.
2. The Area Alarm Module, at the location showing on the Master Alarm’s dis-
play, is connected to the correct gas-specific transducer.
Yes No
L J
Replace the transducer with one that is for the correct type of
gas or vacuum (refer to procedure 4.20 on page 4-50). If this
solves the problem, go to “Final Actions” on page 2-7.
Otherwise, go to step 3.
3. Replace the Area Alarm Module with one that is for the correct type of gas or
vacuum of the line that it is monitoring (refer to procedure 4.9 on page 4-26).
This solves the problem.
Yes No
L J
Call BeaconMedæs Technical Support.
4. Go to “Final Actions” on page 2-7.