PassFinder AP2520 VoIP Router/Gateway Operation Manual
Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd.
-
333
-
router(config)#
router(config)#
dial-peer voice 0 pots
router(config-dialpeer-pots-0)#
destination-pattern 100
router(config-dialpeer-pots-0)#
port 0/0
In case of above example, if calling number “1001234” is received from network
side, number “1234” is transmitted to peer side via ISDN PRI or R2 signaling
interface.
z
If a user does not want to register the E.164 number of peer side in gatekeeper, use the
following command.
router(config-dialpeer-pots-0)#
no register e164
5.8.7.
VoIP Outgoing Call Scenario
z
At first, a PBX internal-line user presses the prefix KEY number (example, 9,etc) after off-hook.
After prefix KEY input, PRI line is hunted, if digit input method is overlap, a user can hear the
dial-tone from VoIP gateway. After hearing the dial-tone, a user presses the called party number.
If PBX digit input method is enbloc mode, END OF DIGIT # key must be pressed after dialing. In
case of overlap mode, END OF DIGIT # key input is optional.
z
AddPac VoIP gateway performs the H.323 outgoing call procedure according to dial-plan using
called party address number received from PBX signaling interface. In this time, calling party
address is internal-line number received from PBX signaling interface as a default mode. If a
user want to change the calling party number, number translation of voice port or voice peer is
necessary. As an example, if a user want that calling party number of all outgoing call is
translated as “ 2002000” number, it will be solved by following command procedures.
router(config)# translation-rule 0
router(config-translation-rule#0)# rule 0 . 2002000%88
router(config-translation-rule#0)# exit
router(config)# dial-peer voice 1000 voip
router(config-dialpeer-voip-1000)# translate-outgoing calling-number 0
5.8.8.
VoIP Incoming Call Scenario
z
VoIP incoming call uses the enbloc digit transmission method. If destination pattern of dial-peer
