PassFinder AP2520 VoIP Router/Gateway Operation Manual
Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd.
-
90
-
[Procedure]
Step
Operation
1
Go to the configuration mode.
2
Enable the static Gateway process.
3
Set the source address and the static route for the destination network.
4
Use “show” command and check if the route is correctly set in the routing
table.
5
With “Ping” command, check if the route can reach the network.
1.
The next-hop address to set during setting up the static route shall be
directly connected with the Gateway to set.
2.
The default route is one of static routes, and the setting method of the
default route is same as that of the static route. However, the
destination address shall be zero subnet (0.0.0.0 address and 0.0.0.0
mask) in the zero network, and the next-hop address shall be same
with that of the static route.
[Related Commands and Syntax]
z
router static
Enables or disables a certain routing process.
z
route
<
destination-IP-network
> <
address-mask
> { <
next-hop-address
> /
Ethernet / null
} [ ( 0/1)/<null_int_#> ] [sub_int_#]
1.
Designates the route to send the packet to the destination address.
2.
When using the candidate default (default route,) both of the
destination address and the mask filed shall be zero.
3.
The Gateway shall be able to recognize the “next-hop-address”
(directly connected port or where the Gateway can reach through
dynamic protocol.)
Caution
