PassFinder AP2520 VoIP Router/Gateway Operation Manual
Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd.
-
100
-
[Procedure]
Step
Operation
1
Go to the configuration mode.
2
Go to the interface configuration mode.
3
Enter into the IP configuration mode..
4
Enable OSPF protocol in the interface.
5
Set the area-ID to which the interface is going to belong.
6
Set other necessary parameters (authentication and so on.)
7
Make the (main) interface up.
8
Enable the OSPF process.
9
Use
“
show
”
command and check if the route is correctly set in the
routing table.
10
With “Ping” command, check if the route can reach the network.
11
(For a fault) use “debug” command to find fault causes and take proper
measures.
When setting the OSPF, enable the OSPF process after setting OSPF in the
interface. If the user does not keep the above procedure, OSPF may not
normally function.
[Related Commands and Syntax]
z
router
{
static/rip/ospf
}
Enables or disables a certain routing process.
z
ospf enable
Enables the OSPF in the corresponding interface.
z
ospf area-id
<
ospf-area-value
>
Sets the area-ID to which the corresponding interface is going to belong.
Caution
