PassFinder AP2520 VoIP Router/Gateway Operation Manual
Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd.
-
95
-
z
rip receive
{
1/2/12
}
Decides which RIP – v1, v2 or v1/v2 – receives routing information through
the interface.
z
rip metric
<
metric_value
>
1.
Designates RIP metric (hop-count) for routing information that is sent
through the corresponding information.
2.
If the metric value is 16 or higher, RIP routing considers the network
unreachable and drops the network from the routing table.
z
rip {default-information/static-information}
1.
When the router sends RIP routing information, the router re-distributes
static route information or default route information to the RIP process
before sending RIP routing information.
2.
If the user uses this command, the user does not need to set
default/static router information in every network device. Instead, the
user only needs to enable RIP routing. Then, every network device will
have the same route table.
z
rip auth-type
{
simple/md5
}
An optional command to decide whether to use authentication or not
when the interface and the neighboring router exchange routing
information. The manager shall set the authentication method – the
simple text method or the MD4 encryption method.
z
rip auth-key
<key-string>
Sets key value for authenticating routing information exchange between
the interface and the neighboring router. (This key value must be set
when authentication is used, and it must be the same with the key value of
the neighboring router.)
z
rip convergence
{split-horizon/hold-down/poison reverse}
Enables options - split-horizon, hold-down timer and poison reverse.
Normally, it is recommended to enable all these options in the RIP network.
However, in the hub port equipment of the Non-Broadcast Multi-Access
