PassFinder AP2520 VoIP Router/Gateway Operation Manual
Version 1.10 / Mar. 2002
AddPac Technology Co., Ltd.
-
94
-
[Procedure]
Step
Operation
1
Go to the configuration mode.
2
Enable the RIP process.
3
Go to the interface configuration mode.
4
Enter into the IP configuration mode..
5
Enable RIP protocol in the interface in which RIP is going to be used.
((If necessary) set RIP version to use.)
6
(If necessary) change RIP related setting.
7
Set other necessary parameters (authentication and so on.)
8
Make the (main) interface up.
9
Use
“
show
”
command and check if the route is correctly set in the
routing table.
10
With “Ping” command, check if the route can reach the network.
11
(For a fault) use “debug” command to find fault causes and take proper
measures.
1. The PassFinder AP2520 router support authentication among RIP neighbors.
(The simple text method and the MD5 encryption method.)
2. The PassFinder AP2520 router can enable/disable split-horizon,
holddown-down and poison-reverse for each interface as using the RIP option.
3. RIP versions to be used in the PassFinder AP2520 router shall be defined for
each interface. Unless there is any separate setting, RIP version 1 is used.
[Related Commands and Syntax]
z
router
{
static/rip/ospf
}
Enables or disables a certain routing process.
z
rip send
{
1/2/12
}
Decides to which RIP – v1, v2 or v1/v2 – to send routing information through
the corresponding information.
Caution
