11-7
IM AQ1300-01EN
VLAN T
est
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
App
Index
VLAN1 and VLAN2
Set the TPID (Tag Protocol Identifier), CFI (Canonical Format Indicator), CoS (Class of Service),
and VLAN-ID for 1 or 2 VLAN stacks. You can refer to the VLAN table to set the values.
• TPID: 0 to FFFF
• CFI:
0 or 1
• CoS: 0 to 7
• ID:
0 to 4095
When VLAN stacks is set to 1, the word “Target” appears by the VLAN1 ID, and you cannot set
the ID.
When VLAN stacks is set to 2, the word “Target” appears by the VLAN2 ID, and you cannot set
the ID.
IPv4
Select whether to specify the source IPv4 address manually or to acquire and set it automatically
through DHCP. This setting is valid when Test Layer is set to L3-IPv4 Test.
• Manual: You must set the source IPv4 address manually.
• DHCP:
When you press Get IP Address, the AQ1300 acquires and sets the source IPv4
address using DHCP.
Source IPv4 Address, Subnet Mask, and Gateway
Set the source IPv4 address, subnet mask, and gateway when IPv4 is set to Manual. You can refer
to the IP Address table and the gateway reference to configure the settings.
• Netmask: 1 to 31
IPv6
Select whether to specify the source IPv6 address manually or to specify it through stateless
autoconfiguration using the RA from an IPv6 router. This setting is valid when Test Layer is set to
L3-IPv6 Test.
• Manual:
You must set the source IPv6 address manually.
• Stateless Address: When you press Get IP Address, the AQ1300 automatically configures the
source IPv6 address.
Source IPv6 Address
Set the source IPv6 address when IPv6 is set to Manual. You can refer to the IP address table to
set the address.
IPv6 Router Address
You can automatically acquire the router address or set it manually.
• Automatic: Clear the Set Router Address manually check box. The IPv6 prefix length and router
address that have been acquired automatically are displayed.
• Manual: Select the Set Router Address manually check box. You can manually set the prefix
length and router address.
MAC Address Table
Select the source MAC address from the MAC Address table.
• Global Address: You can set the source MAC address to a global address.
VLAN Table
Select the VLAN CoS and ID from the VLAN table.
IP Address Table
Select the source IP address from the IP address table.
• Get IP Address: Press this soft key to get the IP address. The AQ1300 will acquire an IP
address, using DHCP when the test layer is L3-IPv4 or stateless address
autoconfiguration when the test layer is L3-IPv6.
11.3 Configuring Link Address Settings
