4-5
IM AQ1300-01EN
Automatic T
est Settings (Auto)
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
App
Index
4.3 Configuring Link and Address Settings
Procedure
Link Setting Screen
Follow the procedure in section 4.1 to display the Auto Setup screen.
Press the
Link/Address
soft key and then the
Link Setting
soft key to display the following screen.
Set the negotiation (Auto, Manual)
This setting is valid when Test Interface is set
to RJ-45 or SFP(GbE).
Set the speed (1G, 100M, 10M, Auto).
This setting is valid when Test Interface is set
to RJ-45.
The Auto setting for Speed is valid when
Negotiation is set to Auto.
Set the duplex (FULL, HALF, Auto).
This setting is valid when Speed is set to
100M or 10M.
The Auto setting for Duplex is valid when
Negotiation is set to Auto.
Set the flow control (ON, OFF).
Set the MDI (MDI, MDI-X, Auto).
The Auto setting for MDI is valid when
Negotiation is set to Auto.
Link Setting Acquisition
Executes link setting information
acquisition
Acquires the link setting information of
the other device connected to the
AQ1300/AQ1301
Applies link settings
Applies the acquired other device’s link
settings to the AQ1300/AQ1301. You can
execute this when the measurement
interface is RJ-45 or SFP(GbE) and the
acquisition status is Finish.
Status (Preparing, Finish, Fail)
Cable type (Straight, Cross)
This setting is valid when Test Interface is
set to RJ-45.
Returns to the link setting screen
Result of link setting information acquisition
• Negotiation (Auto, Manual)
• Speed (1G, 100M, 10M)
Appears when Test Interface is set to RJ-45
• Duplex (Full, Half, −−− (when negotiation is
set to manual))
Appears when Test Interface is set to RJ-45
• MDI (MDI, MDI-X)
Appears when Test Interface is set to RJ-45
This item appears when Test Interface
is set to RJ-45 or SFP(GbE).
Select this check box to automatically
detect mismatches in the auto negotiation
during link establishment.
UTP Cable Status
Indicates the UTP cable status as follows.
(Normal, The cable may be defective, It is
two-pair cable)
