4-6
IM AQ1300-01EN
Source Address Screen
Press the
Link/Address
soft key and then the
Source Address
soft key to display the following
screen.
Set the source MAC address.
Set the VLAN stack number (None, 1, 2).
Configure the VLAN settings (CoS: 0-7,
ID: 0-4095, TPID: 0-FFFF).
These settings are valid when VLAN
stacks is set to 1 or 2.
Set the source IPv4 address.
Set the subnet mask (1-31).
Set the gateway.
These settings are valid when IPv4 is set
to Manual.
Set IPv4 (Manual, DHCP).
This setting appears when Test Layer is
set to L3-IPv4.
Refer to the MAC Address table.
Refer to the VLAN table.
Refer to the IP Address table.
Refer to the gateway reference.
Set IPv6 (Manual, Stateless Address).
This setting appears when Test Layer is
set to L3-IPv6.
Select this check box when you want to
manually set the router address.
Refer to the IP Address table.
View and set the IPv6 prefix length
and the IPv6 router address.
Set the source IPv6 address.
This setting is valid when IPv6 is set to Manual.
MAC Address Table
Press
Refer
next to the MAC address to display the following screen.
Select a global MAC address.
MAC Address Table
Use the setup software to create this table.
Select the source MAC address from
the MAC Address table.
4.3 Configuring Link and Address Settings
