13-8
IM AQ1300-01EN
Source Address Setup Screen
• Standalone
Follow the procedure in section 13.1 to display the Y.1564 Setup screen.
Press the
Link/Address
soft key and then the
Source Address
soft key to display the Source
Address Setup screen.
• MasterDevice
Follow the procedure in section 13.8 to display the Y.1564 Setup screen.
Press the
Link/Address
soft key and then the
Source Address
soft key to display the Source
Address Setup screen.
• SlaveDevice
Follow the procedure in section 13.9 to display the Source Address Setup screen.
Set the source MAC address.
Set the VLAN stack number (None, 1, 2).
Configure the VLAN settings (CoS: 0-7,
ID: 0-4095, TPID: 0-FFFF).
These settings are valid when VLAN
stacks is set to 1 or 2.
Set the source IPv4 address.
Set the subnet mask (1-31).
Set the gateway.
Set the QoS field (ToS: 0-7).
Set the TTL (1-255).
These settings are valid when IPv4 is set
to Manual.
Set IPv4 (Manual, DHCP).
This setting appears when Test Layer is
set to L3-IPv4.
Refer to the MAC Address table.
►section 4.3
Refer to the VLAN table. ►section 4.3
Refer to the IP address table.
►section 4.3
Refer to the gateway reference.
►section 4.3
Set the source UDP port.
Set IPv6 (Manual, Stateless Address).
This setting appears when Test Layer is
set to L3-IPv6.
Set the source IPv6 address.
These settings are valid when IPv6 is set
to Manual.
View and set the IPv6 prefix length and
the IPv6 router address.
Refer to the IP Address table.
Select this check box when you want to
manually set the router address.
13.4 Configuring Link Address Settings
