6-46
IM AQ1300-01EN
Tx Mode Setting Screen
Press the
Detail Setup
soft key and then the
Tx Mode Setting
soft key to display the following screen.
Set the Tx mode
(Continuous, Frames, Time).
Set the time (1-86400 s).
This setting appears when Tx Mode is set
to Time.
Set the number of frames
(1-4294967295).
This setting appears when Tx Mode is set
to Frames.
BERT Rx Screen
Press the
Detail Setup
soft key and then the
Bert Rx Setting
soft key to display the following screen.
Set the oversize threshold
(65-10000 bytes).
Select this check box to set the Tx
frame payload as the comparison
location.
Set the offset (byte 0-255).
This setting is valid when the “Start Pattern
comparison from Payload of Tx Frame”
check box is cleared.
Set the timeout period for detecting
sync loss (None, 2s).
Configure the frames.
►
section 6.5
Frame structure indication
Set the Rx base filter methods.
Configure the Rx base filters.
►
section 6.5.
Select a check box to use the
corresponding Rx base filter.
Set how Rx base filters 1 and 2 are
combined (AND, OR).
Set the frame pass condition
(Match, Mismatch).
Select this check box to include error
frames in the BERT.
6.9 Configuring a BERT
