12-9
IM AQ1300-01EN
E-OAM T
est
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
App
Index
RF Response Setting
You can select whether or not to automatically respond with an RF when Test Interface is set to
XFP(10GbE) and a linkdown is detected or an LF is received.
• Auto: The AQ1300/AQ1301 automatically responds with an RF.
• Manual: The AQ1300/AQ1301 does not automatically respond with an RF.
Continuing to Transmit while the Link Is Down
When Test Interface is set to XFP(10GbE), you can specify whether to continue or stop transmission
after a linkdown is detected.
• Selected: Transmission continues when a linkdown is detected.
• Cleared: Transmission stops when a linkdown is detected.
Tx Clock Source Setting
Specify the Tx clock source for when Test Interface is set to XFP(10GbE) or SFP(GbE).
When Test Interface is set to SFP(FE) or RJ-45, the Tx clock source is fixed to the internal clock.
• Internal CLK:
The internal clock is used.
• Received CLK: The AQ1300/AQ1301 synchronizes with the Rx line signal.
When Test Mode is set to Loopback Test, if Test Interface is set to XFP(GbE) or SFP(GbE), the
AQ1300/AQ1301 uses the received clock regardless of the Tx clock source setting.
Link Setting Acquisition
If the interface is SFP(GbE) or RJ-45, you can acquire and display link setting information of the
other device (DUT; the device on the user side) connected to the AQ1300/AQ1301. For details, see
section 4.3.
Source Address Screen
Source MAC Address
Set the source MAC address. You can refer to the MAC address table to set the address.
VLAN Stacks
Set the number of VLAN stacks.
• None: No VLAN stacks
• 1:
One VLAN stack
• 2:
Two VLAN stacks
VLAN1/VLAN2
Set the TPID (Tag Protocol Identifier), CFI (Canonical Format Indicator), CoS (Class of Service),
and VLAN-ID for 1 or 2 VLAN stacks. You can refer to the VLAN table to set the values.
• TPID: 0 to FFFF
• CFI: 0 or 1
• CoS: 0 to 7
• ID: 0 to 4095
MAC Address Table
Select the source MAC address from the MAC Address table.
• Global Address: You can set the source MAC address to a global address.
VLAN Table
Select the VLAN CoS and ID from the VLAN table.
MD (Maintenance Domain) Level
Set the test target domain level.
MDLevel: 0 to 7
12.4 Configuring Link Address Settings
