11-4
IM AQ1300-01EN
11.3 Configuring Link Address Settings
Procedure
Link Setting Screen
Follow the procedure in section 11.1 to display the VLAN Test Setup screen.
Press the
Link/Address
soft key and then the
Link Setting
soft key to display the following screen.
Set the negotiation (Auto, Manual).
This setting is valid when Test Interface is set
to RJ-45 or SFP(GbE).
Set the speed (1G, 100M, 10M, Auto).
This setting is valid when Test Interface is set
to RJ-45.
The Auto setting for Speed is valid when
Negotiation is set to Auto.
Set the duplex (FULL, HALF, Auto).
This setting is valid when Speed is set to
100M or 10M.
The Auto setting for Duplex is valid when
Negotiation is set to Auto.
Set the flow control (ON, OFF).
Set the MDI (MDI, MDI-X, Auto).
The Auto setting for MDI is valid when
Negotiation is set to Auto.
Source Address Screen
Press the
Link/Address
soft key and then the
Source Address
soft key to display the following
screen.
Set the source MAC address.
Set the VLAN stack number (1, 2).
Configure the VLAN settings (TPID:
0-FFFF, CFI: 0-1,CoS: 0-7, ID: 0-4095).
When VLAN stacks is set to 1, the word
“Target” appears by the VLAN1 ID, and
you cannot set the ID.
When VLAN stacks is set to 2, the word
“Target” appears by the VLAN2 ID, and
you cannot set the ID.
Set the source IPv4 address.
Set the subnet mask (1-31).
Set the gateway.
These settings are valid when
IPv4 is set to Manual.
Set IPv4 (Manual, DHCP).
This setting appears when Test Layer is
set to L3-IPv4.
Refer to the MAC Address table.
► section 4.3
Refer to the IP address table.
►section 4.3
Refer to the gateway reference.
►section 4.3
Refer to the VLAN table. ►section 4.3
Set IPv6 (Manual, Stateless Address).
This setting appears when Test Layer is
set to L3-IPv6.
Set the source IPv6 address.
This setting is valid when IPv6 is set to
Manual.
View and set the IPv6 prefix length and
the IPv6 router address.
Refer to the IP Address table.
Select this check box when you want to
manually set the router address.
