6-16
IM AQ1300-01EN
Variable Field Setting Screen
Press
Detail
next to Field to display the following screen.
Set the method
(Field, Offset).
Set the field.
This setting is valid when Method is set to
Field.
(MAC-DA, MAC-SA, VLAN-ID,
VLAN-CoS, IPv4-ToS, IPv4-DSCP,
IPv4-DA, IPv4-SA, IPv4-Protocol,
IPv6-DA, IPv6-SA, IPv6-TrafficClass,
IPv6-DSCP, IPv6-NextHeader, L4-DP,
L4-SP)
The items that you can set vary depending
on how the settings in the Tx Setting
screen and the frame structure and VLAN
settings in the Frame Setting screen are
configured.
Set the offset.
This setting is valid when Method is set to
Offset.
Offset (0-9998 bytes)
Bit offset (0-31 bits)
Bit width (1-32 bits)
Set the input format (DEC, HEX).
Set the upper and lower limits of the
adjustment range
(DEC: 0-4294967295, HEX: 0-FFFFFFFF).
The range varies depending on the
specified bit width.
Set the adjustment step (+1, Random).
Tx Rate Screen
Press the
Detail Setup
soft key and then the
Tx Rate
soft key to display the following screen.
Set the traffic format
(Constant, Burst).
Select this check box to send frames at
rates that exceed 100% of the Tx rate
(when this check box is selected, the Tx
rate can only be set in bits).
Set the Tx rate
(when Frame Length is set to 64 bytes and
Test Interface is set to XFP).
Percentage range: 0.00001-100.00000
Bit range: 72-9999999424
fps range: 1.00000-14880952.38095 fps
Set the unit (%, bit, fps).
Set the burst number (1-65535).
Set the interval
(1-1000000 us, 1-1000 ms).
Set the unit (us, ms).
These settings are valid when the traffic
format is “Burst.”
6.5 Configuring a Traffic Test
