6-25
IM AQ1300-01EN
Manual T
est Settings (Manual)
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
App
Index
Minimum and Maximum Values
Set the field adjustment value range.
When Type is set to Offset: 0 to 4294967295 (DEC) or 0 to FFFFFFFF (HEX)
The range varies depending on the specified bit width.
When Type is set to Field:
Field
Range
DEC
HEX
MAC-DA/MAC-SA
*
0 to 4294967295
0 to FFFFFFFF
VLAN-ID
0 to 4095
0 to FFF
VLAN-CoS
0 to 7
0 to 7
IPv4-ToS
0 to 7
0 to 7
IPv4-DSCP
0 to 63
0 to 3f
IPv4-DA/IPv4-SA
0 to 4294967295
0 to FFFFFFFF
IPv4-Protocol
0 to 255
0 to FF
IPv6-TrafficClass
0 to 7
0 to 7
IPv6-DSCP
0 to 63
0 to 3f
IPv6-DA/IPv6-SA
*
0 to 4294967295
0 to FFFFFFFF
IPv6-NextHeader
0 to 255
0 to FF
L4-DP/L4-SP
0 to 65535
0 to FFFF
* The least significant 32 bits are adjusted.
Step
Select the field adjustment step.
• +1: The length is adjusted within the specified range in steps of +1.
• Random: The length is adjusted within the specified range randomly.
Tx Rate Screen
Traffic Format
Set the traffic format to use when sending frames.
• Constant: Frames are sent at a constant rate.
• Burst: Frames are sent in bursts. (Frame transmission starts and stops repeatedly at a
specified interval.)
Tx Rate
Rate over 100%
Select whether or not to send frames at rates that exceed 100% of the Tx rate.
• Selected: Frames are sent at rates that exceed 100% of the Tx rate.
• Cleared: Frames are not sent at rates that exceed 100% of the Tx rate.
When the “Rate over 100%” check box is selected, the Tx rate can only be set in bits.
When Test Interface is set to SFP(FE), this setting is fixed to off, and you cannot select this check
box to send frames at rates that exceed 100% of the Tx rate.
Tx Rate Value
Set the Tx rate value.
When Frame Length is set to 64 bytes and Test Interface is set to XFP(10GbE).
• Percentage range: 0.00001 to 100.00000%
• Bit range:
72 to 9999999424 bits
• fps range:
1.00000 to 14880952.38095 fps
Unit
Set the Tx rate unit.
%, bit, fps
6.5 Configuring a Traffic Test
