6-26
IM AQ1300-01EN
Burst Setting
These settings are valid when the traffic format is “Burst.”
Burst Number
Specify the number of burst frames.
Range: 1 to 65535
Interval
Set the interval.
1 to 1000000 us, 1 to 1000 ms
Unit Setting
Set the unit of the interval.
us, ms
Tx Mode Setting Screen
Tx Mode
Set the Tx mode.
• Continuous: In this mode, frames are transmitted continuously. After you start transmission, it
continues until you stop it.
• Frames:
In this mode, a specified number of frames is transmitted. After you start
transmission, the specified number of frames is sent, and then transmission is
stopped automatically.
• Time:
In this mode, frames are transmitted for a specified period of time. After you start
transmission, it continues for the specified period of time and is then stopped
automatically.
Frames
When Tx Mode is set to Frames, set the number of frames.
Range: 1 to 4,294,967,295
Tx Time
When Tx Mode is set to Time, set the Tx time.
Range: 1 to 86400 s
Rx Setting Screen
Oversize Threshold
Set the threshold for determining oversize frames.
Range: 65 to 10000 bytes
Detect Payload Error
Select whether or not to detect payload errors.
• Selected: Payload errors are detected.
• Cleared: Payload errors are not detected.
Offset
You can specify the offset from the start of the payload frame.
• Match to Tx Setting: The offset is based on the source setting.
• Manual:
You must set the offset manually.
Offset Byte Setting
Specify the offset byte for when Offset is set to Manual.
Range: Byte 0 to 255
6.5 Configuring a Traffic Test
