5-11
IM AQ1300-01EN
Automatic (Remote Control) T
est Settings (Auto(Remote))
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
App
Index
VLAN Table
Select the VLAN CoS and ID from the VLAN table.
IP Address Table
Select the source IP address from the IP Address table.
• Get IP Address: Press this soft key to get the IP address. The AQ1300/AQ1301 will acquire
an IP address, using DHCP when the test layer is L3-IPv4 or stateless
autoconfiguration when the test layer is L3-IPv6.
Gateway
Set the gateway.
• Manual: Select this option to set the gateway manually.
• Auto.1:
Select to automatically set the gateway to xxx.xxx.xxx.1.
• Auto.254: Select to automatically set the gateway to xxx.xxx.xxx.254.
Destination Address Screen
Destination MAC Address
Set the destination MAC address. You can refer to the MAC Address table to set the address.
IPv4
Set the destination IPv4 address. This setting is valid when Test Layer is set to L3-IPv4 Test. You
can refer to the IP Address table or select Search List to set the address.
IPv6
Set the destination IPv6 address. This setting is valid when Test Layer is set to L3-IPv6 Test. You
can refer to the IP Address table or select Search List to set the address.
Search List
Select the address of the other device (the destination address) from the search list.
Searching for Other Devices
When you select Search other Device, the AQ1300/AQ1301 searches for other devices (AQ1300 or
AQ1301) on the same VLAN or network segment and displays the results in the search list.
Switching the Display
You can switch between different search list displays.
• SVer: The equipment name, serial number, and version are displayed.
• Test Setup:
The equipment name, test interface, and test layer are displayed.
• MAC: The equipment name, status, and MAC address are displayed.
• IPv4/IPv6:
The equipment name and IP address are displayed.
• Master Addr: The device name and master address (MAC or IP address) are displayed.
Note
You can check the equipment name and serial number of the AQ1300/AQ1301 in the system settings.
Setting the Address Type
You can switch the address type that is displayed when Switch is set to Master Addr.
• MAC address
• IP address
Manual Setting
Press this soft key to cancel the selection that you made in the search list and enter the destination
address manually. This soft key is valid when you have selected a destination address from the
search list.
5.4 Configuring the Master Settings
