1-55
IM AQ1300-01EN
Features
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
App
Index
CIR Test (STEP1 to STEPn)
Traffic within the committed information rate is sent for the specified time (T seconds), and the Tx
rate is increased in steps (STEP1 to STEP n). Traffic parameters (IR, FL, FTD, FDV) are measured
in each step.
You can set up to seven steps.
EIR Test
Traffic at the summed rate of the committed information rate (CIR) and excess information rate (EIR)
is sent for the specified time (T seconds).
When colors (green and yellow) are assigned to frames, green frames are sent at the CIR rate and
yellow frames at the EIR rate. Traffic parameters (IR, FL, FTD, FDV) are measured for each frame
(green, yellow, and total).
When colors are not assigned to frames (OFF), traffic parameters are measured for Total.
Traffic policing Test
Traffic at the summed rate of the committed information rate (CIR) and 125% the excess information
rate (EIR×125%) is sent for the specified time (T seconds).
When colors (green and yellow) are assigned to frames, green frames are sent at the CIR rate and
yellow frames at 125% the EIR rate. Traffic parameters (IR, FL, FTD, FDV) are measured for each
frame (green, yellow, and total).
When colors are not assigned to frames (OFF), traffic parameters are measured for Total.
Note that red frame assignment and measurement result display are not available. Red frames
correspond to the portion of traffic that exceeds the EIR.
• Margin (M)
If necessary, you can set a margin on the upper limit of the excess information rate for policing
tests.
Red frames correspond to the portion of traffic that exceeds this margin.
Example: For the Tx rate of “CIR+EIR 1250 Mbps” on the previous page, if the margin (M) is
set to 10.000 Mbps, red frames correspond to the portion of traffic that exceeds 1260
Mbps.
1.20 Y.1564 Test
