6-12
IM AQ1300-01EN
6.5 Configuring a Traffic Test
Procedure
Traffic Setup Screen
Follow the procedure in section 6.4 to display the Traffic Setup screen.
Tx Setting Screen
Press the
Detail Setup
soft key and then the
Tx Setting
soft key to display the following screen.
Set the offset (byte 0-255).
This setting is valid when Manual is
selected.
Set the payload check offset
(Use Tx Frame setting, Manual).
Select this check box to adjust the
frame length.
Configure the frame length settings.
Select this check box to adjust field
settings.
Configure field adjustment.
Configure the frame settings.
Frame structure indication
Set the frame length (48-9999 bytes).
Actual frame length indication
Contents
Target field
Frame Setting Screen
Press
Detail
next to Frame Structure.
Press the
Basic Setting
soft key to display the following screen.
Set the pattern value (0-FFFFFFFF).
This setting is valid when Manual is
selected.
Configure error addition
(Unused, CRC Error, Symbol Error).
Select this check box to refer to the
source address for the VLAN settings.
Set the VLAN stack number (None, 1, 2).
This setting is valid when the “Refer to
Source Address for the VLAN Setting”
check box is cleared.
Set the frame length (48-9999 bytes).
Actual frame length indication
Set the frame structure
(MAC+TYPE, MAC+TYPE+IPv4,
MAC+TYPE+IPv4+UDP,
MAC+TYPE+IPv6,
MAC+TYPE+IPv6+UDP).
Set the fill pattern
(ALL0, ALL1, 0/1 alt., Random, Manual).
Frame Setting (Basic setting) Screen
