3
Ethernet Speed Setting
The Device's Ethernet Interface has speed settings of
Auto
(10 BASE-T/100 BASE-TX),
100 BASE-TX
(Half or Full Duplex), and
10 BASE-T
(Half or Full Duplex). By default the Ethernet Port Configuration will
be set to
Auto
.
To Change the Network Speed
Go to your Device
1.
Press the
Log In / Out button
on the Control Panel.
2.
Press the
"1" key
on the numeric keypad five consecutive times. (This is the factory default
"password.")
3.
Press
Enter
on the touch screen.
4.
Press the
Machine Status button
on the Control Panel.
5.
Press the
Tools tab
.
6.
Press
Connectivity & Network Setup
.
7.
Press
Protocol Settings
.
8.
When the Protocol Settings menu displays, press the selection line labeled
Ethernet Rated Speed
.
9.
Press the
Change Settings button
.
10. On the Ethernet Rated Speed screen note which one of the buttons is highlighted as the current
setting for Ethernet speed. The available settings are Auto (10 BASE-T/100 BASE-TX), 100 BASE-TX
(Half or Full Duplex), and 10 BASE-T (Half or Full Duplex). The default setting is Auto.
11. To change settings, press your setting of choice, then press the
Save
button.
12. To exit the Ethernet Setting screen, without making any changes, press the
Cancel
button.
13. To exit the Protocol Settings menu, returning to the Tools tab screen, press the rectangular
Close
button.
14. Wait several seconds and the Auto Clear service should log you out.
Note that if you changed any settings in the Protocol Settings menu, the Device will automatically
reboot to register and enable your new settings.
Summary of Contents for WorkCentre 7300 Series
Page 1: ...System Administrator s Guide 701P47983 WorkCentre 7300 Series ...
Page 12: ...x ...
Page 203: ......
