Xerox WorkCentre 7300 Series, Administrator'S Manual, Page: 13 / 203

1
Network Connectivity
Installation Steps
Step 1. Connect one end of a Category 5 twisted pair cable to a live network drop. Connect the opposite
end of the cable to the RJ-45 socket at the rear of the Device.
Step 2. Set the Device's power switch to ON and wait until the Main screen is displayed.
Note: The actual screen displayed as the Main screen is selectable. To determine the screen you
would like displayed, press the Log In / Out button, enter the Administrator password (default of 11111),
touch Enter, press the Machine Status button, and touch the Tools tab. Touch Common Service Settings,
touch Screen/Button Settings, select Service Screen Default, touch Change Settings, make your selection
and touch Save. Touch Close until the Tools tab is displayed. Wait for the Auto Clear service to log you
out.
Step 3. Refer to the Configuration Report topic in this guide and print a Configuration Report using the
instructions supplied.
Step 4. Referring to the Configuration Report, determine if the appropriate ports and protocols are
enabled for your Network environment.
To support communicating with the Device's Internet Services, a series of internal Web Pages that enable
remote configuration of operating settings, the TCP/IP protocol stack should be enabled. The Device
should also have a valid IP Address, Subnet Mask, and Gateway displayed. If this is not the case, go to
the
NOS Selection section of this guide, locate the TCP/IP Protocol Configuration topic, and follow the
instructions supplied.
Machine
Status
Log In / Out
All Services