137
To enable IP Sec:
1.
Open your Web browser and enter the TCP/IP address of the machine in the Address or Location field.
Press
Enter
.
2.
Click the
Properties
tab.
3.
Click the symbol to the left of the
Security
folder.
4.
Select
IP Sec
in the directory tree.
5.
Enable the Protocol by placing a checkmark in the
Enabled
box.
6.
Select
Pre-Shared Key
to use the Shared Secret (between this device and remote computers also
possessing the secret). Note that if you select Digital Signature, the Shared Secret boxes will be
grayed out and you will have to supply a Certificate stored on this device to the remote computer that
wishes to send IP Sec encrypted data to this device. Refer to the Configuring certificates with
CentreWare Internet Services topic in this Encryption section for full information.
7.
Enter the Shared Secret (a password) in the
Shared Secret
and
Verify Shared Secret
boxes.
8.
Select
Enabled
(default setting) for the
Communicate with Non-IP Sec Device
setting, so that
computers not set up for encryption can still communicate with this device.
9.
Use the on line Help for assistance with other available settings.
10. Click
Apply
when done and supply the Administrator User Name and Password, if prompted. The
default is 11111 and x-admin.
Scheduled Image Overwrite
A TCP/IP network-connected device can be set to overwrite image data on a scheduled basis.
Note: The Image Overwrite will delete all image data from the hard disk!
To enable a scheduled image overwrite, perform the following steps:
1.
At your workstation:
a.
Open your Web browser.
b.
Enter the IP address of the machine in the Address or Location field.
c.
Press Enter.
2.
Click the [Properties] tab.
3.
If prompted, type or enter your System Administrator user name and password.
•
user name (default): 11111
•
password ( default): x-admin
4.
Click the [Security] folder.
5.
Click the [Scheduled Image Overwrite] link.
Note: The Image Overwrite will delete all image data from the hard disk!
6.
In the Scheduled Image Overwrite area, in the Advanced Settings box, on the Schedule Image
Overwrite line, click [Enabled].
7.
Configure the Frequency, Day, Week, Hour, and Minute settings.
Note: The machine will be taken off line each day at the time specified to perform the overwrite.
8.
Click [Apply]. Restart the device at the prompt.
Summary of Contents for WorkCentre 7300 Series
Page 1: ...System Administrator s Guide 701P47983 WorkCentre 7300 Series ...
Page 12: ...x ...
Page 203: ......
