95
Enabling Ports and Setting TCP/IP
In order to use the job flow service, you must enable the SOAP port, the SNMP port, the Internet Service
(HTTP) port, and set IP addresses. The procedure for setting the machine is as follows.
Note: The configuration can also be performed using CentreWare Internet Services.
For information on how to use CentreWare Internet Services, refer to the Internet Services section of
this guide.
1.
Display the System Administrator Menu screen.
a.
Press the
Log In/Out
button.
b.
Enter the user ID with the numeric keypad, or the keyboard displayed on screen, and select
Enter
.
Note: The default user ID is “11111”. When using the Authentication feature, a password is required.
The default password is “x-admin”.
c.
Press the
Machine Status button
on the Control Panel, then touch the
Tools tab
.
2.
Enable the SOAP port.
a.
Select
Connectivity & Network Setup
.
b.
Select
Port Settings
.
c.
Select
SOAP
and then select
Change Settings
.
d.
Select
Port Status
and then select
Change Settings
.
e.
Select
Enabled
then select
Save
.
f.
Select
Close
until the Port Settings screen is displayed.
3.
Enable the SNMP port.
a.
Select
SNMP
and then select
Change Settings
.
b.
Select
Port Status
and then select
Change Settings
.
c.
Select
Enabled
then select
Save
.
d.
Select
Close
until the
Port Settings
screen is displayed.
e.
Enable the
Internet Service (HTTP) port
using the same process as stated above.
f.
Select
Close
repeatedly until the
Tools tab
screen is displayed.
4.
Set an IP address.
If an IP address is already set, this step is not necessary.
Also, in an environment with DHCP or
BOOTP, configure the way to obtain an IP address. If the address cannot be obtained automatically, or
static configuration is preferred, configure an IP address, a subnet mask, and a gateway address as
follows.
a.
Select
Protocol Settings
.
b.
Select
IPv4 (or other mode) Address Resolution
and then select
Change Settings
.
c.
Select one from [DHCP], [BOOTP], [RARP], [DHCP/Autonet] or [Static], and then select Save. If
you select anything other than [Manual], proceed to Step 5.
Note: When communicating by TCP/IP make sure to enable the use of a DNS (or WINS for SMB)
server. This is done using the machine’s Internet Services web pages, displayed by typing the
machine’s IP address into your web browser (as stated in the TCP/IP Dynamic Addressing Topic of
this guide).
d.
On the Protocol Settings screen, select
TCP/IP – IP Address
and then
Change Settings
.
e.
Enter the IP address using the numeric keypad.
Summary of Contents for WorkCentre 7300 Series
Page 1: ...System Administrator s Guide 701P47983 WorkCentre 7300 Series ...
Page 12: ...x ...
Page 203: ......
