Wintriss SmartPAC PRO Servo, User Manual

Page: 173 / 228

SmartPAC PRO Servo User Manual 1147100
Chapter 6
– Run Mode
173
When you select DIPROPAC 17-32, the Die Protection Sensor menu for sensors 17-32 displays (see
Figure 6-16, which shows the sensors that are used as examples in Chapter 5).
Figure 6-14. Die Protection Sensor Menu for Sensors 17-32
When programmed as green sensors, sensors 17-32 cannot be adjusted in Run mode since they share
their Ready signals or stroke counts with one of the first sixteen sensors. You can, however, adjust the
Ready signal or stroke count for the sensor on which settings are based. Adjustments are
automatically duplicated in all linked sensors 17-32.
The Die Protection Sensor menu for sensors 17-32 allows you to view the Sensory Summary and
Sensor Status screens (see page Figure 6-14) for those sixteen sensors.
When you select a sensor programmed as green, green quick check, or green constant on the Die
Protection Menu for Sensors 17-32, the Run mode Ready Signal Programming screen displays with a
message, located underneath the status box, indicating that you cannot change Ready signal timing
for this sensor (see Figure 6-15). If you want to change timing, you must change the timing for the
sensor in the group of sensors 1-16 whose Ready signal is being used for the sensor you are
programming.