Wintriss SmartPAC PRO Servo, User Manual

Page: 45 / 228

SmartPAC PRO Servo User Manual 1147100
Chapter 2
– Installation
45
2. Making sure that you are grounded, install the new board by plugging it into the appropriate
connector. Connectors are keyed, so you can only plug in the boards in one direction.
3. When the board is properly seated, screw it down to the four standoffs, using the screws that
came with the kit.
4. Remove the connector(s) from the board, one connector for an 8-sensor or 8-cam unit, two
connectors for a 16-sensor or 16-cam unit, four connectors for a 32-sensor unit. Terminal block
assignments for the different boards are as follows:
•
DiProPAC 8: Sensors 1-8 to TB554
•
DiProPAC 16: Sensors 1-8 to TB554, sensors 9-16 to TB554
•
DiProPAC 32: Sensors 1-8 to TB554, sensors 9-16 to TB554, sensors 17-24 to TB555, and
sensors 25-32 to TB555
•
ProCamPAC 8: Cam channels 1-8 to TB401
•
ProCamPAC 16: Cam channels 1-8 to TB451, channels 9-16 to TB452
5. Wire the connector(s) to the appropriate component(s). For the DiProPAC board, wire the
connector(s) to the DiPro Sensor Interface, following the instructions in
Connecting DiPro
Sensor Interface to SmartPAC PRO Servo , page 45. For the ProCamPAC board, wire the
connector(s) to the ProCam Output assembly, following the procedure in Connecting
Programmable Cam Channels , page 49.
6. Plug the connector(s) back into their sockets on the board.
7. Verify that you have installed the board(s) properly by performing Verifying Installation of
DiProPAC and ProCamPAC , page 57. You need to complete this procedure before you can use
SmartPAC PRO Servo.
Connecting DiPro Sensor Interface to SmartPAC PRO
Servo
To connect your DiPro die protection sensors through the DiPro Sensor Interface (DSI) 2, refer to
Table 2-3, below, to wire sensors 1-8
Table 2-4, page 47, to wire sensors 9-16
Table 2-5, page 48, to wire sensors 17-24
Table 2-6, page 48, to wire sensors 25-32.
Wiring diagrams (Figure 4 for sensors 1-16, Figure 5 for sensors 17-32) are provided at the end of the
manual. Terminate cable shields to ground studs close to the point of entry into the enclosure. Refer
to the DSI 2 manual for more information.
NOTICE
DSI 2 NOT COMPATIBLE WITH LOW-IMPEDANCE SENSORS
If any of your sensors are low-impedance types, they must be wired directly to DiProPAC. Low-
impedance sensors cannot be wired to DSI 2.