Wintriss SmartPAC PRO Servo, User Manual

Page: 74 / 228

1147100 SmartPAC PRO Servo User Manual
74 Chapter 4
– Initialization Mode
Counter Setup Mode
(INITIALIZATION
– POSITION SENSOR)
This item allows you to enable or disable counter setup mode if you have made the appropriate wiring
connections to make SmartPAC PRO Servo “setup mode ready” (see
Wiring Setup Mode Circuit ,
page 55.) To set this parameter, do the following:
1. Press ENTER to toggle between two settings:
•
“IS INCREMENTED IN ALL MODES”– The parts and batch counters will increment on
every stroke no matter what mode (i.e., Inch, Single-stroke, or Continuous) you are in.
•
“NOT INCREMENTED IN SETUP MODE”–The Parts counter and batch counters whose
increment mode is programmed as GOOD PARTS will not increment when you are in Inch
mode.
NOTICE
The Strokes counter will increment regardless of the mode you are in.
2. When the setting you want is displayed, press Back.
Counter Increment Mode
(INITIALIZATION
– POSITION SENSOR)
This item allows you to specify whether the Good Parts counter increments during a fault condition.
The default setting, NO INC FAULT, prevents the counter from incrementing when there is a fault.
To set this parameter, do the following:
1. Press ENTER to toggle between two settings:
•
“NO INC FAULT”–The Parts counter and batch counters whose increment mode is
programmed as GOOD PARTS will increment on every stroke except when there is a fault
condition. This is the default setting.
•
“INC ALWAYS”–The Parts counter and batch counters whose increment mode is
programmed as GOOD PARTS will increment on every stroke even if a fault condition is
present.
2. When the setting you want is displayed, press Back.