Wintriss SmartPAC PRO Servo, User Manual

Page: 95 / 228

SmartPAC PRO Servo User Manual 1147100
Chapter 4
– Initialization Mode
95
Security Access Menu Item Security Access Settings
ADJ RAM POSITION PROGRAM AND RUN MODES
PROGRAM MODE ONLY
PASSWORD REQUIRED
INIT. PASSWORD NOT REQUIRED
MUST BE USED
Setting Security Access
NOTICE
CHECK YOUR PASSWORDS
Make sure to check your passwords before changing any security access settings. Record the
passwords in a safe place. Refer to
Changing Passwords , page 96.
NOTICE
DO NOT ENABLE INIT. PASSWORD UNTIL YOU HAVE CHECKED YOUR PASSWORDS
Field upgraded SmartPAC PRO Servos may have different passwords than those listed in this
manual. If you do not know the Initialization password and change the INIT. PASSWORD item to
MUST BE USED, you will not be able to access the Main Initialization Menu.
NOTICE
BE CAREFUL WHEN SETTING RESET MODE SECURITY ACCESS
If you select the PROGRAM MODE ONLY or PASSWORD REQUIRED setting for the RESET
MODE item, the operator will not be able to reset SmartPAC PRO Servo in Run mode when the
press stops as the result of a malfunction.
•
If you want the operator to be able to reset the machine in Run mode following errors, select
PROGRAM AND RUN MODES as the Reset Mode setting.
•
If you want one person to be responsible for tracking faults, give that individual the
Program/Run key, and set Reset Mode access to PROGRAM MODE ONLY. When a fault
occurs, that individual can reset the press by turning the key switch to PROG and pressing the
RESET key, then resume press operation by turning the key back to RUN.
To make security access settings, do the following:
1. Select SECURITY ACCESS on the Main Initialization Menu to display the Security Access
Menu (Figure 4-21, page 92). Note that the factory settings allow all actions to be performed in
both Program and Run modes.
2. To change the security access of an item, highlight the item, using the Up (

) and Down (

)
cursor keys, then press ENTER one or more times until the type of access you want displays.
Refer to Table 4-5, page 94, for help with selecting access options.
3. Press EXIT to save your settings and return to the Main Initialization Menu.