Wintriss SmartPAC PRO Servo, User Manual

Page: 142 / 228

1147100 SmartPAC PRO Servo User Manual
142 Chapter 5
– Program Mode
screen also shows the number of the sensor in the group of sensors 1-16 whose stroke count is
being used as the stroke count for the sensor you are programming.
Figure 5-43. Sensor Settings Screen
6. Press RESET to return to the Die Protection Sensor 17-32 Menu.
CAM SWITCH
(PROGRAM
– GO TO THE TOOL MANAGER – SELECT TOOL – EDIT TOOL – CAM SWITCH)
PROGRAMMABLE CAM SWITCH NOT FOR SAFETY USE
Use SmartPAC PRO
Servo’s programmable cam switch to control auxiliary functions only. The
SmartPAC PRO Servo programmable cam capability should never be used to provide timing
signals for any safety use including muting of light curtains.
Failure to comply with these instructions will result in death or serious injury.
NOTICE
MAXIMUM NUMBER OF TIMED CHANNELS PER TOOL
Each tool can have up to four Timed Output cam channels.
CAUTION
Some Servo presses are capable of hitting the same part more than once at Bottom Dead Center
(BDC) before returning to the top of the stroke. You will have to note the angle ranges at which
repeated strokes occur. Any cams programmed within these ranges will actuate once for each hit.
Die protection ready signals programmed within these ranges will expect sensor actuation once for
each hit. If this is not feasible, please contact Wintriss Tech. Support to learn about new advanced
features.
Failure to comply with these instructions could result in property damage.