Wintriss SmartPAC PRO Servo, User Manual

Page: 84 / 228

1147100 SmartPAC PRO Servo User Manual
84 Chapter 4
– Initialization Mode
Enabling Setup Mode
Setup mode allows you to run the press in Inch without incrementing the good parts and batch
counters or triggering a fault condition in the green sensors. This mode, as its name indicates, is used
during setup. You enable Setup mode by selecting the Inch setting.
NOTICE
To enable Setup mode, your inch-selector switch must be wired to the Setup mode input, terminal
#252 on TB105 (see
Wiring Setup Mode Circuit , in Chapter 2)
To enable Setup mode, do the following:
1. Select SENSOR ENABLE MODE on the Main Initialization Menu. The Die Protection Mode
Selection Menu displays, Figure 4-15.
2. Move the highlight bar to the SETUP MODE item.
3. Press ENTER to toggle the setting from DISABLED to INCH, then press Exit to return to the
Main Initialization Menu.
LINEAR SENSOR
(INITIALIZATION
– LINEAR SENSOR)
NOTICE
Make sure to select a transducer that is at least as long as or longer than the sum of the maximum
stroke length of your press and the maximum shut-height adjustment.
NOTICE
CONNECT SWITCH TO DISABLE INTERRUPTED CYCLE FAULTS DURING SETUP
For ease in setting up and configuring the Linear Sensor, wire a switch between TB5 pin 252
(Setup) and TB5 pin 250 (Gnd). Refer to the wiring diagrams in the back of this manual.
When the switch is closed to ground, this disables interrupted cycle faults.
After you set up the transducer and it is functioning properly, open the switch or remove it.
This item enables you to set up the magnetostrictive linear transducer for use with your press. You set
the resolution for the sensor, the sensor’s zero value, the maximum Upper Limit in the sensor’s range,
the offset to apply to the sensor’s upper and lower limits, and the units in which Upper Limit, Lower
Limit, and Offset Value are measured. You make these settings on the Linear Sensor Setup screen,
Figure 4-16.