Wintriss SmartPAC PRO Servo, User Manual

Page: 171 / 228

SmartPAC PRO Servo User Manual 1147100
Chapter 6
– Run Mode
171
Viewing Sensor Status
(RUN
– DIE PROTECTION –SHOW SENSOR STATUS)
You can view the status of your sensors by pressing SHOW SENSOR STATUS. When you do so, the
Sensor Status screen, shown in Figure 6-12, page 172, displays.
The Sensor Status screen shows the status of every sensor for a loaded tool. Sensor inputs are
identified by the numbers 1 through 8 (for 8-sensor DiProPAC) or 1 through 16 (for 16-sensor
DiProPAC). The type of sensor connected to each input is indicated by the following abbreviations,
which appear beneath the blocks representing the sensors.
•
G = Green
•
GQC = Green Quick Check
•
GCON = Green Constant
•
GS = Green Special (Number of required strokes is shown to the right of “GS”)
•
RED = Red
•
YEL = Yellow
•
N/U = Not Used
If the sensor block is dark, the sensor is actuated. If it is white, the sensor is not actuated.
The Sensor Status screen is designed so that you can quickly check the status of all your sensors and
correct programming or wiring mistakes. When a sensor signals a fault, you can use the display to see
the status of all your sensors at the stroke angle at which the press stopped.
When you select the screen with the press running, the actuation blocks for green sensors will flash as
they actuate once every stroke. (Due to the slow update rate of this screen, some sensor actuations
may be missed.) An actuation block for a green special sensor will flash every preset number of
strokes.
A red sensor actuation block is always actuated except when there is a sensor fault, since it is
normally grounded. Actuation blocks for yellow sensors are only actuated during a fault condition.
When the press is stopped, the actuation block shows the state of the sensor at that point in the stroke.
The actuation block for an unused sensor may display if a sensor has been connected to that input by
mistake. The Sensor Status screen shows any change in the state of an input whether the input is
being used or not.