Wintriss SmartPAC PRO Servo, User Manual

Page: 162 / 228

1147100 SmartPAC PRO Servo User Manual
162 Chapter 6
– Run Mode
Figure 6-3
. “Enter General Password” Screen
When you enter the password, you are given access to the item.
When a Run mode item is set to PROGRAM MODE ONLY, NO CHANGES ALLOWED, ALLOW
RECALC ONLY, or NO RECALC/ADJUST, you are prevented from gaining access to that item. No
message displays to indicate that the setting is locked, but when you press ENTER to access the item
or press the cursor buttons to make an adjustment, nothing happens. When the LOAD NEW TOOL
item is locked out, that entry does not appear on the Main Run Menu.
Displaying Multiple Faults
Whenever more than one fault occurs in response to a press condition, the message for the first fault
displays in a window on the Main Run Menu and the DISPLAY ALL ERRORS button appears. Press
it to view the multiple errors. A large red message window opens, as shown in Figure 6-4, with each
fault listed in sequence beneath the caption “ALL PENDING ERRORS.” To close the window, press
RESET.
Figure 6-4. Display All Errors Message Window
Opening the Ram Angle Window
You can open a window displaying the ram angle at a magnification comparable to that on the ram
angle clock on the Main Run Menu for use on Run mode screens where a prominent ram angle