Wintriss SmartPAC PRO Servo, User Manual

Page: 118 / 228

1147100 SmartPAC PRO Servo User Manual
118 Chapter 5
– Program Mode
Figure 5-15. Counter Mode Selections Screen
2. Move the highlight bar to the setting in the OUTPUT MODE column for the Batch counter you
want to program, then press ENTER to scroll through the three options (i.e., TOP STOP,
TOGGLE, and PULSE) until the setting you want is displayed.
NOTICE
When you select TOGGLE or PULSE, the ProCamPAC channel associated with output from that
batch counter displays on the Counters screen (Figure 5-12, page 114).
3. If you selected PULSE as the output mode in step 2, move the highlight bar to the PULSE TIME
(MSEC) column, and press ENTER. The Numeric Entry window displays.
4. Key in a value for the cam channel On time in milliseconds (maximum value, 9,999 mS, or about
10 seconds), following the instructions in the window, then press ENTER. The value you keyed
in displays in the PULSE TIME (MSEC) column for the specified Batch counter.
5. Move the highlight bar to the INCREMENT MODE column, then press ENTER to toggle
between the STROKE and GOOD PARTS options until the setting you want is displayed.
6. Repeat steps 2 through 5 for other Batch counters, as necessary.
7. Press RESET to return to the Counters screen.
Setting Counter Increment Angle
The ram angle at which counters are incremented is set at the factory to a default value of 270°. This
value is satisfactory for counting parts, but if you have programmed Batch counter outputs to control
automation, increment angles for those counters should be set to the angle at which you want the
automation to activate. The Counter Mode Selections screen allows you to set a common increment
angle for Strokes, Good Parts, and Batch 1 counters and separate increment angles for Batch 2 and
Batch 3 counters. To change default increment angles, do the following: