Wintriss SmartPAC PRO Servo, User Manual

Page: 198 / 228

1147100 SmartPAC PRO Servo User Manual
198 Glossary
error message A message appearing on the SmartPAC PRO Servo LCD that indicates a fault
condition, identifies the problem, and may suggest how to correct it.
manual enable A die protection mode in which sensors are manually enabled or disabled by the
operator.
messaging A SmartPAC PRO Servo feature that allows e-mails to be sent from SmartPAC
PRO Servo to networked computers, pagers, text-enabled cell phones and other
devices. This feature is set up in SmartView.
NEMA 12 A rating that certifies that an electrical device is protected against dust, water,
and oil. on-off setting Stroke angle settings at which the cam channel is to turn
“on” and “off.”
OSHA Stands for Occupational Safety and Health Administration, a government
agency that has established regulations for mechanical power presses including
presence-sensing devices for point-of-operation guarding.
ram angle clock A graphical indicator on the SmartPAC PRO Servo display that shows the
position of the press’s ram in degrees.
reset A command issued by the operator that allows the press to resume operation
after it has been stopped due to a malfunction. The “reset” command clears the
fault message from the SmartPAC PRO Servo display. The command is issued
by pressing the RESET key.
security access
Settings made in Initialization that control the amount of access SmartPAC PRO
Servo users are given to SmartPAC PRO Servo functions.
smart stop A type of stop programmed for a die protection sensor that sends an emergency
stop to the press when a sensor fault occurs before the critical angle or a top stop
if the fault occurs after the critical angle. See
critical angle , emergency stop , and
top stop .
suppressor A component that reduces or eliminates electrical noise.
tool template
A tool on the Tool Manager screen that you can program with settings shared by
multiple tools, then use as a “template” to copy the common settings to those
tools.
top stop A signal sent to the press in response to a malfunction that stops the press at the
top of its current stroke (0°).
total hits
counter A counter that maintains a count of the total number of hits made by a tool, used
in determining when a tool needs regrinding. See
counter .