Wintriss SmartPAC PRO Servo, User Manual

Page: 117 / 228

SmartPAC PRO Servo User Manual 1147100
Chapter 5
– Program Mode
117
Figure 5-14. Change Count Confirmation Window
3. Press the Up (

) cursor key to proceed with the Change Count process. The value you entered in
step 2 displays in the COUNT field for the counter you selected in step 1.
4. Repeat steps 1 through 3 for each count you want to change.
Clearing the Total Hits Counter
Since the Total Hits counter does not reset to zero (0) when its preset is reached, you must reset the
counter manually. To do so, perform the following steps:
1. On the Counters screen, select the setting displayed in the COUNT column for TOTAL HITS.
2. Press the CLEAR key. The Change Count Confirmation window displays, Figure 5-14, asking
you to confirm that you want to change the COUNT value.
3. Press the Up (

) cursor key to proceed with the Change Count process and clear the Total Hits
count. The value in the COUNT column for TOTAL HITS is reset to zero (0).
Setting Batch Counter Output and Increment Modes
If you set a Batch counter preset value on the Counters screen, you must also specify the output and
increment modes for that counter if they differ from the factory settings. By default, output mode is
set to TOP STOP, increment mode to STROKE. To change these settings, perform the following
steps:
1. On the Counters screen, press SET COUNTER MODES. The Counter Mode Selections screen
displays, Figure 5-15.