Wintriss SmartPAC PRO Servo, User Manual

Page: 91 / 228

SmartPAC PRO Servo User Manual 1147100
Chapter 4
– Initialization Mode
91
8.
If you want to specify a unit that is not in the list, select “CUSTOM.” When the on-screen
keyboard displays, key in a unit of up to 6 characters and press Enter. You are returned to the
Tool Information Setup screen with the unit you created displayed.
9. Highlight the zero (0) on the first line in the PLACES column, and press ENTER. When the
Numeric Entry window displays, key in the number of decimal places you want displayed for this
item on this tool. Then press ENTER.
For numeric values, you can select up to four decimal places. For YES/NO items, enter eight (8)
for the number of places. Table 4-4 provides additional information about decimal place formats.
Table 4-4. Tool Information Setup Screen: Decimal Places and Formats
No. of
Places
Example
Digits to Left of
Decimal Point Digits to Right of
Decimal Point
Range
0
Whole numbers:
press speed (SPM)
Up to seven (7) None (0)
0 to
9,999,999
1 Up to five (5) One (1)
0.0 to
99,999.9
2 Die location (mm) Up to four (4) Two (2)
0.00 to
9,999.99
3
Pass line height
(inches)
Up to three (3) Three (3)
0.000 to
999.999
4
Precise values:
material thickness
Up to two (2) Four (4)
0.0000 to
99.9999
8
Yes or No
designation
Not applicable Not applicable
NO (0)
YES (1)
NOTICE
Do not change the number of decimal places on the Tool Information Setup screen after you have
entered any values for specific tools in Program or Run mode. If you change the number of decimal
places, entered values will be changed by a factor of ten for each decimal place added or removed.
10. Repeat steps 2-9 to set up other Tool Information items. A Tool Information Setup screen with
sample entries filled in is shown in Figure 4-20.